I’m just wondering if the initial boot up requires a higher amount of current than 850ma… as 9 times out of 10, the SSP will not boot using my Waldorf KB37, even if it’s the only module plugged in. I’ll see the initial logo, and then it will restart and not get past that moment.
The KB37 switching PSU is rated for +12/1.5A -12/1.5A and on power-up it’s not protecting itself from over-current situation - so I’m not sure what’s up there.
Thankfully, no issues booting on my main rig with my Acopian Linear supplies.
Anyone else try this in a KB37?