Processor Menu

How can I change the parameters of my modules?

  • Select the module in the network that you’d like to change parameters for.
  • Go to the Proc menu.
  • Use the 4 encoders to change the parameter values of the selected module.

Per default the group of parameters in red are the ones which you can change using the encoders. To switch to the other group of parameters (in grey), press “enc +” or “enc -” to switch to the other group, and again use the encoders to change parameter values.

Overview of all the modules on the SSP (work in progress please feel free to create a new wiki page for each module)


“VST” is listed here but it isn’t available in my module list, and I have a freshly re-imaged SD card with the latest update.

VSTs (such as mine) are now loaded directly… so they are seen as ‘proper modules’.

previously you had the VST module, which you would then have to select the vst… but this had a few limitations, so in the later firmware, Bert changed it so you could load VSTs directly.

1 Like