so, i have a MIDI controller that sends values 0-127
how do i need to set the scale and offset value so that sending a 0 value the SSP translates that into -5V ?
now, when i send (MIDI) 0 value, the SSP sends 0V, and when i send MIDI value 127, the SSP give 5V
(i never get below 0)
edit : MIDI cc never gives 5V, although the bar/scope goes all the way up, the value mapped only goes half
load a GRA, pick a rather long wave, assign MIDI cc A and/or B to GRA start and or length
move your MIDI control all the way up (value 127) and you’ll see that the position line in the GRA only goes until half of the wave, same with length // if you change the start/length value with a knob (all the way to 1.000), you’ll see that the position liner goes all the way, the complete wave